LT3500
19
3500fc
Figure 7. Synchronous Signal Powered from Regulators Output
LT3500
SYNCHRONIZATION
CIRCUITRY
LDRV
PG
R
T
/SYNC
3500 F07
V
CC
CLK
current proportional to the voltage at the V
C
pin. Note that
the output capacitor integrates this current, and that the
capacitor on the V
C
pin (C
C
) integrates the error ampli er
output current, resulting in two poles in the loop. In
most cases a zero is required and comes from either the
output capacitor ESR or from a resistor in series with C
C
.
This simple model works well as long as the value of the
inductor is not too high and the loop crossover frequency
is much lower than the switching frequency. A phase lead
capacitor (C
PL
) across the feedback divider may improve
the transient response.
Synchronization
The R
T
/SYNC pin can be used to synchronize the LT3500
to an external clock source. Driving the R
T
/SYNC resistor
with a clock source triggers the synchronization detection
circuitry. Once synchronization is detected, the rising edge
of SW will be synchronized to the rising edge of the R
T
/SYNC
pin signal. An AGC loop will adjust slope compensation
to avoid subharmonic oscillation.
The synchronizing clock signal input to the LT3500 must
have a frequency between 250kHz and 2.5MHz, a duty
cycle between 20% and 80%, a low state below 0.5V and
a high state above 1.6V. Synchronization signals outside
of these parameters will cause erratic switching behavior.
The R
T
/SYNC resistor should be set such that the free
running frequency ((V
RT/SYNC
V
SYNCLO
)/R
RT/SYNC
) is
approximately equal to the synchronization frequency. If
the synchronization signal is halted, the synchronization
detection circuitry will timeout in typically 10約 at which
time the LT3500 reverts to the free-running frequency based
on the current through R
T
/SYNC. If the R
T
/SYNC pin is held
above 1.1V at any time, switching will be disabled.
If the synchronization signal is not present during regu-
lator start-up (for example, the synchronization circuitry
is powered from the regulator output) the R
T
/SYNC pin
must see an equivalent resistance to ground between 15k
and 200k until the synchronization circuitry is active for
proper start-up operation.
If the synchronization signal powers up in an undetermined
state (V
OL
, V
OH
, Hi-Z), connect the synchronization clock
to the LT3500 as shown in Figure 7. The circuit as shown
will isolate the synchronization signal when the output
voltage is below 90% of the regulated output. The LT3500
will start-up with a switching frequency determined by the
resistor from the R
T
/SYNC pin to ground.
APPLICATIONS INFORMATION
If the synchronization signal powers up in a low impedance
state (V
OL
), connect a resistor between the R
T
/SYNC pin
and the synchronizing clock. The equivalent resistance
seen from the R
T
/SYNC pin to ground will set the start-up
frequency.
If the synchronization signal powers up in a high impedance
state (Hi-Z), connect a resistor from the R
T
/SYNC pin to
ground. The equivalent resistance seen from the R
T
/SYNC
pin to ground will set the start-up frequency.
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LT3507HUHF#TRPBF
IC REG QD BUCK/LINEAR 38-QFN
LT3570IFE#TRPBF
IC REG BUCK/BST/LINEAR 20TSSOP
LT3645HMSE#TRPBF
IC REG DL BUCK/LINEAR 12-MSOP
LT3694IFE-1#TRPBF
IC REG TRPL BUCK/LINEAR 20TSSOP
LT4220IGN#TR
IC CTLR HOTSWAP DUAL 16-SSOP
LT4250LCN8
IC CONTRLR HOT SWAP NEG 48V 8DIP
LT4254CGN
IC CTRLR HOTSWAP POSVOLT 16SSOP
LT4256-1IS8#TRPBF
IC CTRLR HOTSWAP HV LATCH 8SOIC
相关代理商/技术参数
LT3500HMSE-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500HMSE-TRPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500IDD#PBF
功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500IDD#TRPBF
功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500IDD-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500IDD-TRPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500IMSE#PBF
功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500IMSE#TRPBF
功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*